Xerox DocuMate 4790 User Manual page 176

Hide thumbs Also See for DocuMate 4790:
Table of Contents

Advertisement

If you are unable to resolve the issue using the troubleshooting steps in this table, please refer to the
section
Troubleshooting
Error
Code
Message
U11 - U18 Paper Jam and Paper
Remains in Scanner
errors.
U20
A skew error has
occurred.
U23
A paper double feed
has occurred.
U24 - U26 A stapled document
has been detected.
U30 - U34 A cover is open.
176
Xerox DocuMate 4790
User's Guide
on page 190.
Cause
Paper has jammed while
being fed through the
scanner.
Document sensors are
dirty.
A page was pulled into
the scanner at an angle.
Two pages have fed
through the scanner at
the same time.
Either the page bent
when it was picked up
from the input tray, or
the page skewed greatly
as it was pulled into the
scanner.
A scanner access cover is
open.
Resolution
Open the scanner, remove the pages, then
close the scanner. Please see page 189 for
complete instructions.
If problem persists, clean the rollers and
paper sensors as described in the section
Cleaning the Inside of the Scanner
page 183.
Open the scanner, remove the pages, then
close the scanner. Adjust the paper guides to
the document width. Restack the paper in
the ADF and click Retry to continue.
If problem persists, clean the rollers and
paper sensors as described in the section
Cleaning the Inside of the Scanner
page 183.
Open the scanner, remove the pages, then
close the scanner. Make sure there are no
pages stuck together. Restack the paper in
the ADF and click Retry to continue.
If problem persists, clean the rollers and
paper sensors as described in the section
Cleaning the Inside of the Scanner
page 183.
Open the scanner, remove the pages, then
close the scanner. Check all documents and
remove any staples. Restack the paper in the
ADF and click Retry to continue
Verify all covers on the scanner are fully
closed before scanning.
on
on
on

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents