Imprinter(S) Tab - Xerox DocuMate 4790 User Manual

Imprinter(s) Tab

Use the imprinter tab to set the options for printing data on the pages as they are scanned. The
imprinter options are only available if you have an imprinter unit installed in the scanner.
• Pre-imprinter—prints the character strings defined on this tab on the
pages before the pages are scanned. These strings then appear in the
scanned image. The pre-imprinter only prints on the simplex (face up)
side of the page.
Orientation—select in which direction you want the text printed on the
page. When you select an option from the list, the text to the right shows a
preview of how the text will look on the page.
Vertical start position—drag the slider left or right to set the start
position on the page where you want the text printed. The starting
position of the slider is 10mm (approximately .4 inches) as this is the
minimum required margin from the edge of the paper. You should set the
paper size on the Scan Settings tab before adjusting the Vertical start
position. Click on the label "mm" or "inches" to switch between the two
units of measurement.
152 Xerox DocuMate 4790
User's Guide