Stamina 15-0201 Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 7
NOTE: The RIGHT PEDAL(40) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(40) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is tightened by turning
counter clockwise.
Thread the RIGHT PEDAL(40) into the RIGHT CRANK(9). Thread the LEFT PEDAL(39) into the LEFT
CRANK(8).
STEP 8
Refer to the illustration. Swing the METER BRACKET(27) up to a position where it can be seen while
working out. NOTE: If necessary, loosen or tighten the BUTTON HEAD BOLT(M8x1.25x47mm)(61). The
BUTTON HEAD BOLT(M8x1.25x47mm)(61) should be tight enough to secure and hold the METER(26)
in place yet loose enough for the METER(26) to be adjusted.
Install an AA battery into the METER(26), the battery is not included. See page 11 for detailed battery
installation instructions. Attach the METER(26) to the METER BRACKET(27) with ROUND HEAD
SCREWS(M5x0.8x12mm)(28). Plug the SENSOR WIRE(23) into the METER(26).
9