Verifying Operation - HP StorageWorks 2/32 - SAN Switch Installation Manual

4. Connect the cables to the SFPs as appropriate to the fabric topology by
Figure 16: Inserting a cable into an SFP
Note:
cable does not slide in easily, check the orientation.

Verifying Operation

After making the appropriate connections, as outlined in this chapter, follow these
steps to verify that the switch is running properly.
1. Access your browser.
2. At the URL address window, enter
3. If connected properly, the name of your switch appears in green at the prompt,
SAN Switch 2/32 Version 4.2.x Installation Guide
positioning each cable so that the key (the ridge on one side of the cable
connector) is aligned with the slot in the SFP. See
The cable is keyed so that it can only be inserted correctly into the SFP. If the
indicating Healthy/OK.
Installing the SAN Switch 2/32
Figure
SHR-2574A
http://your switch IP address.
16.
47