Cf_Keystone Command; Cf_Kystnmode Command; Cf_Corner-Ul Command - Sanyo PLC-XU116 - 4500 Lumens Manual

PLC-XU116 Expand Serial Command Functional Specifications
8.7.3

CF_KEYSTONE Command

Command "CF_KEYSTONE_%1"[CR]
"UP" ------------- Correct Keystone distortion to reduce upper part of image
"FUP" ----------- Correct Keystone distortion to reduce upper part by 2steps
"DN" ------------- Correct Keystone distortion to reduce lower part of image
"FDN" ----------- Correct Keystone distortion to reduce lower part by 2steps
%1 "LEFT" ---------- Correct Keystone distortion to reduce left part of image
"FLFT " --------- Correct Keystone distortion to reduce left part by 2steps
"RIGHT" -------- Correct Keystone distortion to reduce right part of image
"FRGT" --------- Correct Keystone distortion to reduce right part by 2steps
"RST" ------------ Return to its default value
Change Keystone distortion correction
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.4

CF_KYSTNMODE Command

Command "CF_KYSTNMODE_%1"[CR]
"STR" --------- Set Keystone store mode to Store
%1
"RST" --------- Set Keystone store mode to Reset
Set Keystone store mode
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.5

CF_CORNER-UL Command

Command "CF_CORNER-UL_%1"[CR]
"UP" ------------ Correct the horizontal line of image upwards
"DN" ------------ Correct the horizontal line of image downwards
%1
"LEFT" --------- Correct the vertical line of image to the left
"RIGHT" ------- Correct the vertical line of image to the right
Correct the top-left corner of the image. (Available in normal Power ON status
only)
The correction starts with the first command received
Details
Projector returns error code ""101 and no operation is made when exceeding the
correction limit,
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"201"[CR] ----When reaching the Keystone correction limit or
reaching 1 step to correction limit and "FDN"/"FUP"
is received.
(The command is not executed)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
30/72