Playback In Zone2 (Separate Room); Audio Output; Playback - Denon AVR-1913 Owner's Manual

Playback in ZONE2 (Separate room)

• You can operate this unit so as to enjoy audio in a room (ZONE2)
other than the MAIN ZONE (room where the unit is located).
• You can simultaneously play back the same source in both the MAIN
ZONE and ZONE2. You can also play back separate sources in the
MAIN ZONE and ZONE2.

Audio output

Zone playback by speaker output
• Set the "Amp Assign" (vpage 113) setting to "ZONE2", and
outputs ZONE2 audio from SURROUND BACK speaker terminals
(The default setting is "ZONE2").
• If you set the"Amp Assign" (vpage 113) setting to "ZONE2", the
main zone home theater system can play back up to 5.1 channels.
Even if you play back audio recorded in 6.1 or 7.1 channels, this unit
automatically downmixes the audio to 5.1 channels.
n Connecting and setting the speakers
"Amp Assign" setting
(vpage 113) and audio Connecting the speakers
signals output
Output signal :
ZONE2
Stereo (L / R)
NOTE
It is not possible to play the digital audio signals input from the HDMI,
COAXIAL or OPTICAL connectors in ZONE2. Play using analog
connections (in stereo).
DVD

Playback

1
Press ZONE2 to switch the zone
mode to the ZONE2.
ZONE2
lights.
2
Press POWER X
ZONE2 power.
The indicator on the display lights.
• Also press input source select button when
in standby mode, the power turns on.
POWER X
• When is pressed, ZONE2 turns
off.
• Power in ZONE2 can be turned on or off by
ZONE2 ON/OFF
pressing
3
Press the input source select
button to select the input source
to be played.
The audio signal of the selected source
is output to ZONE2.
• To perform an operation with the main unit,
ZONE2 ZONE2 SOURCE
press many times.
ZONE2 SOURCE
Each time you press
input source changes.
(L) (R)
w q w q
When power for both MAIN ZONE and ZONE2 is set to ON, power
of the MAIN ZONE only can be turned off. In Step 1, press
POWER X
in this order.
to turn on the
Input source
select buttons
on the main unit.
, the
MAIN
and
91
Adjusting the volume
VOLUME df
Use to adjust the volume.
GAdjustable rangeH 0 – 40 – 98
(When the "Scale" (vpage 102) setting is "0 – 98")
GAdjustable rangeH – – – –79dB – –40dB – 18dB
(When the "Scale" (vpage 102) setting is "–79.5dB – 18.0dB")
• At time of purchase, "Volume Limit" (vpage
(–10dB)".
MASTER VOLUME ZONE2 ON/OFF
Turn after pressing
unit to adjust the sound volume.
Turning off the sound temporarily
MUTE :
Press .
The sound is reduced to the level set at "Mute Level" (vpage 121)
in the menu.
• To cancel, either adjust the volume or press
• The setting can also be cancelled by adjusting the volume or turning
off the ZONE2 power.
You can adjust the tone and volume for ZONE2 in "ZONE2 Setup"
(vpage 121) in the menu.
121) is set to "70
on the main
MUTE :
again.