Table of Contents
Advertisement
Set up speakers
First install and connect the speakers to this unit.
Before Audyssey ® Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURROUND BACK speaker terminal of this unit can be switched to match your speaker environment
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers
"Set up "Channel Select"").
1
Set up the
remote control unit
n Set up the zone mode
MAIN
Press
to switch the zone mode to the MAIN
ZONE.
MAIN
lights.
Press MAIN
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Start
84
(vpage 84
"Set up "Amp Assign"").
3
Set up "Amp Assign"
ui
Use
to select "Amp Assign", and then press
ENTER
.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Start
Audyssey Setup/Amp Assign
Assign Mode
Assign all amps to the main zone for surround sound
speakers
4
Select "Assign Mode", and then press
around items indicate the settings.
(vpage 85
Surround Back
ZONE2:
ENTER
.
v See overleaf
Advertisement
Table of Contents
