Attaching The Outer-Rail Assemblies - HP D5970A - NetServer - LCII Guía Del Usuario

Chapter 8
2. Use the masking tape (or marking pen) to mark above the 3rd hole up on
both front columns, as shown in Figure 8-3.
#
#
" "
# represents
the EIA unit
numbers on the
#
rack columns.
#
3rd Hole
#
From Bottom
1st Hole
#
From Bottom
Figure 8-3. Location Marks on the Rack's Columns
3. Mark the inside face of the left-rear and right-rear rack columns as shown
in Figure 8-3.

Attaching the Outer-Rail Assemblies

No tools are required to attach the outer-rail assemblies to the rack columns.
1. Pull the anti-tip foot forward out of the bottom of the rack.
See Figure 8-4 for the anti-tip foot location.
2. Lower the leveler screws on the rack's lower four corners to make firm
contact with the floor. See Figure 8-4.
3. Align the left outer-rail to the left front and rear columns as shown in
Figure 8-4.
Rack Mounting the HP Netserver (4-Post)
Left
Masking
Side
Tape
Marker
Bottom of
HP NetServer
Rear of
Rack
Mark this face of
Right
the columns with
Side
masking tape
or marker pen.
Front of
Rack
77