HP D5970A - NetServer - LCII Guía Del Usuario page 59

Chapter 6
Thumb
Latch
Tab
Figure 6-5. Placing the Heatsink on the Processor
CAUTION
Ensure the left ridge on the bottom of the heatsink fits into the
groove between the processor socket and processor, while
both ridges should straddle the processor. If good contact is
not made between the processor and the heatsink, the
processor will overheat and possible damage may occur.
See Figures 6-5 and 6-6.
b. While holding the heatsink steady with one hand, push down and in
toward the center with your finger to hook the tab with the hook latch.
See Figure 6-6.
c. While holding the heatsink down with one hand, push down with your
thumb to hook the tab with the thumb latch. See Figure 6-6.
Installing an Additional Processor
Hook Latch
(hidden)
Step A
Tab
Processor
Socket
53