Remote Control Card - HP D5970A - NetServer - LCII User Manual
Hp netserver lp 2000r (1.13, 1.26 & 1.40 ghz) user guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
Chapter 5
Remote Control Card
The HP Netserver LP 2000r supports the HP Remote Control card, which uses the
HP TopTools remote management software. The Remote Control card requires an
2
I
C connection to the system board, provided by the I
board (Integrated Remote Assistant circuitry) that is installed on the system board.
See Figure 5-1 and Figure 5-2.
For more information on the HP TopTools remote management function, refer to
Chapter 10, "Configuring the HP Netserver," and Chapter 11, "HP Netserver
Online Documentation CD-ROM."
Figure 5-1. Location of I
Installing Additional Boards
2
C connector on the daughter
2
I C Connector
2
C Connector on Integrated RA Board
41
Advertisement
Table of Contents
Troubleshooting
