Setting The Hp Netserver's Power-On Passwords - HP D5970A - NetServer - LCII User Manual

Chapter 10
Once in the Setup Utility, the menu bar appears at the top of the screen with
"User Preferences, Security, Configuration, and Exit" shown. The User
Preferences menu is the default menu and should be the highlighted selection
at the left of the menu bar when the Setup Utility first opens.
3. If necessary, use the up-arrow key to move to the System Time field.
The "System Time" field is highlighted by default when the "User
Preferences" menu is selected. This field actually consists of three
sub-fields enclosed in brackets [xx:xx:xx]: hours to the left (24-hour clock),
minutes in the middle, and seconds to the right.
4. Type in the hour and press Enter to move to the minutes field.
5. Then type in the minutes and press Enter again to move to the seconds field.
6. Type in the seconds and press Enter, then use the arrow keys to leave this
field.
7. Scroll to System Date field to enter the system date in the field.
The dates are entered in the "System Date" field in the same way as the time
is entered in the "System Time" field. This field also has three separate
sub-fields for month, day, and year enclosed in brackets [xx/xx/xxxx].
8. Type in the month and press Enter to move to the day field.
9. Then type in the day and press Enter again to move to the year field.
10. Type in the year and press Enter, and then use the arrow keys to leave this
field.
Ensure you enter all four digits for the year.
11. Use the right-arrow or left-arrow key to select the Exit menu.
12. Choose Exit Saving Changes from the list of exit options, then press Enter.
A dialog appears and asks you to confirm your decision.
13. Choose Yes and then press Enter.
Then the HP Netserver reboots.

Setting the HP Netserver's Power-On Passwords

Use this topic to set a password to boot the HP Netserver.
To configure the HP Netserver for a password, which will require a password on
boot-up, refer to the following procedure.
1. If not already in the Setup Utility, boot or reboot the system and press F2
when prompted.
Configuring the HP Netserver
99