Removing Pci Cards; Installing A Remote Control Card - HP D5970A - NetServer - LCII Installation Manual

Chapter 7

Removing PCI Cards

Apply the same steps as in the installing procedure and simply remove the PCI
card and the PCI retaining bracket. Replace the slot cover. See the preceding
section for details.

Installing a Remote Control Card

Refer to the Top Tools Administration Guide for Remote Control along with the
upgrade kit documentation for information on the remote control card.
1. Connect the four-pin ribbon cable (shipped with the remote control card)
to the remote control card. Refer to the upgrade kit instructions.
2. Route the cable through open spaces in the chassis to the I/O boar d.
3. Connect the cable to the IPMI/I
Figure 7-6. IPMI/I
46
Installing Additional Boards
2
C connector on the I/O board.
2
C Connector to Remote Control Card