HP D5970A - NetServer - LCII User Manual page 41

Chapter 4
9. Align the notches on the DIMM with the keys on the slot. See Figure 4-3.
Keys
DIMM
Slot
30 Degrees
10. Hold the DIMM at approximately 30 ° to the system board and press the
DIMM firmly and evenly into the slot until the retaining latches close.
See Figures 4-3 and 4-4.
It is important to hold the DIMM firmly with both hands and use even
pressure so as not to bend or break the DIMM connector during installation.
If the latches do not close, the DIMM is not inserted correctly.
11. Repeat Steps 7-10 to install additional DIMMs for your memory
configuration.
Retaining Latches (2)
Notches
Figure 4-3. Aligning the DIMM
Installing Additional Memory
35