Clearing The System Configuration - HP D5970A - NetServer - LCII Installation Manual

Chapter 13
If you have changed any switches on the system board, check that they
are properly set.
5. Reseat the system board in the card edge connector to the I/O board.
6. Turn on the display and HP NetServer LPr.
7. If the HP NetServer LPr still does not work:
Repeat steps 1, 2, and 3 of this section.
Remove all accessories, except the primary boot hard disk drive.
Replace the cover and connect all cables.
Turn on the display and the HP NetServer LPr.
If the HP NetServer now works, replace the boards and accessories one
at a time to determine which one is causing the problem.

Clearing the System Configuration

You may need to clear the system configuration if the configuration has been
corrupted by a program, or if incorrect settings made in the Setup utility have
made the display unreadable.
To clear the system configuration, follow the steps on the next pages.
Troubleshooting
101