Step 4-Completing The Computer Assembly - HP Z220 Installation Manual

7.
Replace the locking screws in the sides of the carrier.
Figure 28
Step 4—Completing the computer assembly
CAUTION:
Other procedures may result in system hangs, data loss, or even drive damage. The component
supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the
workstation is booted and then powering the drive via the power switch on the enclosure. Microsoft
Windows XP and Windows Vista do not support this action.
1. After the drive case is installed in the computer, insert the drive carrier into the case.
a.
Press on the left side of the handle (1) to open the door.
b.
Insert the drive carrier.
c.
If shipping or moving the computer, lock the carrier by inserting the key (2) and turning it
counterclockwise (3).
CAUTION:
might result in damage to your removable hard drive system.
Figure 29
ENWW
Replacing the locking screws
Insert or remove the carrier (with a disk drive) only when the workstation is shut down.
Always lock the drive before shipping or moving the computer. Failure to do so
Locking the carrier
Step 4—Completing the computer assembly
17