Hp Z600 And Hp Z800 Computers - HP Z220 Installation Manual

4.
Install one (supplied) 6-32 x 1/4 in. screw (silver) for each DX115 unit for shipping support.
CAUTION:
drive system.
Figure 19

HP Z600 and HP Z800 computers

1. For HP Z800 computers:
Remove the airflow guide to enable access to the optical bays.
●
Remove the card support to enable access to the system board connectors.
●
2.
Remove and discard the counter-sunk shipping screw at the side of the DX115 case. See
Removing the shipping screw on page
3. Lift and hold the drive release latch at the green touch point (1) while sliding the DX115 case into
the bay (2). When the front of the drive is near its final position, release the latch, but continue to
slide the drive inward until the latch closes and engages the drive.
Figure 20
12 CRU Dataport DX115 kit installation
Failure to install the shipping screw might result in damage to the removable hard
Installing the shipping support screw
Installing the DX115 case
7.
Figure 8
ENWW