HP Workstation x1000 User Manual page 25

4. Click the button corresponding to the type of installation you want.
If you select Custom, a list of software components will be
displayed. Select the check boxes to specify the components you
want to install.
5. Click Next to continue the installation.
6. When the DIAMOND Install dialog displays the components to be
installed click on Next. (Depending on which components you
chose different windows might appear. Click on the corresponding
buttons to continue the installation.)
7. When the Installation complete message appears click Next
again. This will restart your computer.
8. After Windows 2000 reboots, the Found New Hardware message
displays the Digital Signature Not Found dialog and prompts
you Do you want to continue the installation? Click Yes to
install and start the drivers.
9. Click Start > Settings > Control Panel > Display >
Settings, or right-click on the Windows desktop, select
Properties and Settings.
10. Set the resolution (Screen area), and color depth that best suit
your requirements and your monitor's performance.
11. Click the Advanced button and select the Monitor tab.
12. Set the refresh rate for the monitor connected to the Fire GL2
graphics accelerator in your system.
13. Click OK until you are on the Windows desktop.
Note: Refer to your Windows 2000 online help and documentation for
further information on using the Monitor and Settings dialogs.
22 Installing the Fire GL2