HP Workstation x1000 User Manual page 20

Start your System
Switch on your monitor before you switch on your computer. Failing to
do so could damage your monitor.
If you have correctly installed the card, operating system messages will
appear on your monitor when the boot procedure is finished.
Note: Your monitor is running in standard VGA mode. Higher
refresh rates etc. are not available at this stage of the installation.
After you have successfully installed the Fire GL2 drivers you can
use the dialogs in the Display Properties menu to adjust the video
settings.
Your System Does Not Start as it Should?
Check again to verify that the installation instructions were
properly followed.
Check that the system BIOS has assigned a system interrupt to the
AGP slot where the card is installed.
Check the system configuration utility of your operating system
for the interrupt assignments.
Inspect your system BIOS setup for an option that says "Assign
IRQ to VGA" or something similar and ensure that this option is
enabled.
Some older ISA legacy add-in cards (with jumpers, non-Plug-n-
Play) may cause a conflict if they are not configured in the ESCD
(extended system configuration data) area of the system BIOS.
Please refer to your computer's User's Guide for information on
using the ISA Configuration Utility ICU to add legacy card resource
requirements to the system.
Please refer to the Troubleshooting section for more information, if it
appears that the card is not performing optimally.
Contact the Technical Support.
Installing the Fire GL2 17