Replacing A Hard Disk Drive (Drive Cage Mounted) - HP Tc2120 - Server - 256 MB RAM Maintenance Manual

Chapter 7
6. Slide the drive out of the drive cage.
Drive Slide Rails
Retaining Clips
7. Remove the four screws to remove the rails from the drive.
8. Place the removed drive in an anti-static bag for protection.

Replacing a Hard Disk Drive (Drive Cage Mounted)

NOTE If the hard disk drive (HDD) you are planning to install
already has a mounting tray attached, you must remove it
before you can install the drive into the drive cage.
1. Set the jumper on the back of the drive to "CS" (Cable Select). Refer to the hard disk drive documentation
for detailed instructions.
2. Align and screw the rails to the new drive.
Use the shoulder screws located above the drive cage.
Figure 7-6. Releasing the Retaining Clips
Replacing Parts
(Do not remove
drive cage from
chassis.)
88