Installing An Optional Backup Tape Drive - HP Tc2120 - Server - 256 MB RAM Maintenance Manual

Chapter 3
Extra
Screws

Installing an Optional Backup Tape Drive

The optional HP SureStore DAT 24i backup tape drive is a single-ended device and may slow down the disk
access time for the Ultra-160 SCSI drives. A second SCSI controller board may be required to separately control
the backup tape drive.
1. If the server is already installed and operating, power-down the server.
Refer to Chapter 1‚ Controls and
2. Disconnect the power cables and any external cables connected to the server.
If necessary, label each one to expedite re-assembly.
3. Remove the left side cover from the server.
Refer to "Opening and Closing the hp server"
4. Remove the upper front bezel.
Refer to "Opening and Closing the hp server"
5. Press in on both tab latches to release the third drive tray and pull it out at the same time. See
6. Remove the RFI shield from the third drive tray. See
7. Ensure that the backup tape drive is not terminated and ensure that the SCSI ID jumper is set for address =
ID 3 on the tape drive.
The optional HP SureStore DAT 24i backup tape drive is shipped with the default setting of SCSI address
= ID 3. Refer to the documentation provided with the tape drive.
8. Install the backup tape drive, as described below:
Figure 3-10. Installing an Optional CD-ROM or DVD Drive
Indicators.
earlier in this chapter.
earlier in this chapter.
Figure 3-11.
Installing and Configuring
Figure 3-11.
25