Phase 2 - Install The Hp Video Driver; Phase 3 - Install The Hp Lan Driver - HP Tc2100 - Server - 128 MB RAM Installation Manual

Chapter 3 Installing Microsoft Windows 2000 Server and Small Business Server 2000
PHASE 2 – Install the HP Video Driver
The Microsoft Windows installation process has installed the standard VGA video
driver. If you would like to make use of the high resolution video driver, follow
these steps:
1. Ensure Microsoft Windows 2000 Service Pack (version #2 or above) is
installed. This is a REQUIREMENT.
2. Logon as the "Administrator" on your HP Server tc2100 then insert HP
Startup CD in the CD-ROM drive. The Startup CD will automatically start
and a menu will display.
NOTE Your HP server should auto-detect the presence of the Startup
CD and start the Startup menu. If your HP server does not
auto-start the Startup menu, start it by opening Startup.htm
which can be found at the root level of the Startup CD.
3. Select "Automated installation of hp video driver for
Microsoft Windows 2000 Server".
4. The HP video driver (ATI video) setup program will open. Click Next to
start the installation then click Yes to accept the License Agreement.
5. Click Finish when prompted to restart your system at the end of the
installation. (remember to remove all diskettes and CD-ROM from their
respective drives).
6. After your logon, you will be notified that default display resolutions are
being used. Click OK. You can now configure your settings and test them.
PHASE 3 – Install the HP LAN driver
Windows 2000 installation automatically detects the HP NIC and installs the
driver bundled with the Windows 2000 CD-ROM. The following procedure will
help you upgrade the driver using the HP Startup CD:
1. Insert the HP Startup CD in your new server. If CD-ROM auto-start is
enabled, a menu will display. You may close this menu.
2. Open Start | Settings | Control Panel | System | Hardware | Device
Manager.
3. Open the "Network Adapters" tree and double-click on the appropriate
adapter to display its menu.
27