HP Tc2100 - Server - 128 MB RAM Installation Manual page 25

Chapter 3 Installing Microsoft Windows 2000 Server and Small Business Server 2000
b. At the "Create partition size" prompt, type 2048 and press Enter.
c. HP recommends that you create all the partitions needed for each hard
drive present on your system. Select unpartitioned space and press C
again to create additional partitions.
8. Select the target drive to be used to install Windows 2000. Press Enter.
9. Select "Format the partition using the NTFS file
system" and press Enter.
10. The installer will format and copy files to the hard drive.
11. If you have selected to install the NetRAID-1M driver, Windows setup will
prompt for the driver diskette again.
12. The system will reboot and launch Windows 2000 graphic interface. Be sure
to remove the driver diskette before the reboot.
13. At the "Installation Wizard" first dialog box, click Next to continue.
14. The "Installing Devices" screen will be shown with a progress bar on the
display. This may take 10 to 15 minutes.
15. You can now proceed through the customization of your installation using
the graphical interface.
NOTE The network settings may need to be customized to your
environment. Please refer to Microsoft 2000 manuals should
you need further details on the networking settings.
16. The "Installing Components Display" screen starts with a progress bar. It
takes about 20 minutes to complete this section.
17. The wizard will then automatically start the "Performing Final Tasks" section
to complete the installation. This step may takes a long time too, with the
progress bar apparently not moving.
NOTE
18. At the "Completing the Windows 2000 Setup Wizard" screen, remove the
CD-ROM then click Finish. The system will automatically reboot from the
hard drive.
19. Follow screen instructions to logon (press Ctrl-Alt-Del). Enter the
administrator password you have defined earlier.
There may be a period of time with no apparent activity at the
"Saves Settings". Be patient.
19