Setting The Sleep Timer; Convenient Functions; Personal Memory Plus Function; Last Function Memory - Denon S32 - Micro System Owner's Manual

Setting the Sleep Timer

Use this function to automatically switch the power to
the function off mode after a specific amount of time
(minutes).
1
Set the current time (vpage 8).
2
SLEEP
During playback, use to select the time.
120 90 60 50 40
Off
b After about 5 seconds, the previous display reappears and the
timer starts.
3
The power is set to the function off mode after the set
amount of time.
Canceling the sleep timer
Press SLEEP, select "Off" from the sleep timer time display.
Checking the time remaining until the sleep timer
starts
Press SLEEP.
Checking the current time
Press DISPLAY or hold down DIMMER for 2 seconds or more.
The time is displayed.

Convenient Functions

Personal Memory Plus Function

This function sets the settings last selected for the
individual input sources.
When you switch to an input source, the settings are
automatically set to the ones that were set the last time
that input source was used.
30 20 10

Last Function Memory

This stores the settings as they were directly before the
standby mode was set.
When the power is turned back on, the settings are
restored to as they were directly before the standby mode
was set.

Backup Memory

The various settings are backed up for about 1 week,
even if the power is turned off or the power cord is
disconnected.
Auto Power On
When the power is in the standby mode, the power turns
on simply by pressing <1/3>.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are
reset to their default values.
1
Remove the power plug.
2
<9> <MUTE / SNOOZE>
While pressing and
simultaneously, plug the power cord into a power outlet.
3
When "INITIALIZE" is displayed, release your
fingers from the two buttons.
When "INITIALIZE" is not displayed in step 3, repeat operations from
step 1.
ENGLISH