Table of Contents
Advertisement
ENGLISH
Advanced Operation
Alarm Setting
Set the alarm time, source and volume.
1
Press
<ALARM SETTING>
to set the alarm.
2
[Alarm number selection]
Thrn
<Multi Jog>
to
select "ALARMl" or
"ALARM2", then press
ENTER.
The time display flashes.
3
[Alarm time setting]
Select time with
<Multi Jog>,
then press
ENTER
to
set.
*
Turn <Multi Jog> clockwise to increment the set value, and counter-
clockwise to decrement it.
4
[Alarm source setting]
Select alarm source with
<Multi Jog>,
then press
ENTER
to set.
5
[Alarm volume level setting]
Select alarm volume level with
<Multi Jog>,
and
press
ENTER
to set.
6
Press
<ALARM1>
or
<ALARM2>,
and set the alarm
on.
• When the input source is CD, iPod or PC Music, if music does not
play when the alarm on time
IS
reached, a Beep will sound.
• Alarms 1 and 2 operate separately.
• If the set is not operated for 60 minutes after alarm playback starts,
playback stops and the power turns off (The Beep sound stops after
5 minutes).
• When you want alarm playback of an iPod recording, set iPod while
pausing the track you want to play.
o
Pausing alarm playback (snooze function)
Press <MUTE / SNOOZE> during alarm playback.
Alarm playback resumes 5 minutes after it was stopped.
o
Stopping alarm playback
Either press <ALARM1> or <ALARM2> on the main unit to turn the
alarm off, or press the main unit's <FUNCTION ON/OFF>.
If there is a power failure
o
When connected to a network
When the power comes back on, the set automatically connects
to an SNTP (Simple Network Time Protocol) server and the current
time is adjusted automatically. Once the zone, daylight saving time
and alarm time have been set, they are stored in the memory, so
there is no need to set them again.
o
When unconnected to a network
When the power comes back on, the clock resumes from the time
the power turned off. If the time is way off, turn the power on and
reset the current time. If the alarm time has been set, it is stored in
the memory, so there is no need to set it again.
Setting the Sleep Timer
Use thiS function to automatically sWitch the power to the
standby mode after a specific amount of time (minutes)
1
Set the current time (n2lf'page 11).
2
During playback, use
SLEEP
to select the time.
r
120 --- 90 --- 60 --- 50 --- 40 --- 30 --- 20 ---10
~
-
Off
_.- - - - - - - '
"*
After about 5 seconds, the previous display reappears and the
timer starts.
3
The power is set to the function off mode after the set
amount of time.
Canceling the sleep timer
Press SLEEP, select "Off" from the sleep timer time display.
Checking the time remaining until the sleep timer
starts
Press SLEEP.
Checking the current time
Press [DISPLAY] or hold down DIMMER for 2 seconds or more.
The time is displayed.
27
Advertisement
Table of Contents
