Secondary 3.5-Inch Internal Hard Drive - HP Rp5700 - Point of Sale System Reference Manual

Secondary 3.5-Inch Internal Hard Drive

A Torx T-15 screwdriver is needed to remove and install the guide screws on a hard drive.
CAUTION:
before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard
drive, you will need to run the Restore Plus! CD to load the HP factory-installed files.
CAUTION:
If you are inserting or removing a hard drive, shut down the operating system properly, then turn off the
computer. Do not remove a hard drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. Refer to
about preventing electrostatic damage.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
1. Prepare the computer for disassembly
2. Remove the computer cover
3. Raise the drive cage to the upright position.
NOTE:
Figure 7-47
100 Chapter 7 Removal and Replacement Procedures — Small Form Factor (SFF) Chassis
Make sure personal files on the hard drive are backed up to an external storage device
To prevent loss of work and damage to the computer or drive:
Electrostatic Discharge Information on page 54
(Computer Cover on page
It is not necessary to remove the drives from the drive cage.
Rotating the Drive Cage Up
(Preparation for Disassembly on page
64).
for more information
61).
ENWW