Front Bezel - HP Pro 4300 Maintenance And Service Manual

Front Bezel

The front bezel is located on the front of the computer and is secured to the main system bracket with
five Torx screws and nine tabs.
You can remove the front bezel without disassembling many of the computer's components. Most
components can remain attached to the base pan. The following procedure demonstrates removing
the bezel while removing the smallest number of components possible.
To remove the front bezel:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the top panel (see
6. Remove the rear cover (see
7. Remove the speakers (see
8. Remove the power switch assembly cable from the front bezel. You do not have to remove the
remaining cables.
9. Remove the five black Torx screws that secure the bezel to the main system bracket assembly.
10. Lift the nine tabs (see arrows in image) that secure the bezel to the main system bracket
assembly. Be sure to slide the bracket free from the tabs as you lift each one.
26).
Top Panel on page
Rear Cover on page
Speakers on page
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
51).
55).
66).
27).
29).
31).
Front Bezel 77