Hard Disk Drive Jumper Settings; Installing A Security U-Bolt - IBM NetVista Hardware Maintenance Manual
Hardware maintenence manual for netvista 6838 and 6848 systems
Hide thumbs
Also See for NetVista:
- Hardware maintenance manual (211 pages) ,
- Hardware manual (135 pages) ,
- Guide utilisateur (124 pages)
Table of Contents
Advertisement
Hard disk drive jumper settings
IDE hard disk drives for the NetVista series computers use jumpers to set the
drives as primary (master) or secondary (slave).
Installing a security U-bolt
To install a U-bolt, do the following:
1. Remove the cover.
32
IBM NetVista Type 6838, 6848: Hardware Maintenance Manual
Note: For drives not shown below, refer to the label on the hard disk drive for the hard
disk drive settings.
1 Primary (Master) Hard Disk Drive
2 Secondary (Slave) Hard Disk Drive
Advertisement
Table of Contents
