Installing Memory Modules - IBM NetVista Hardware Maintenance Manual

2. Remove the two metal knockouts.
1
2
3
3. Insert the U-bolt through the rear panel. Attach and tighten the nuts with an
4. Replace the computer cover. See "Replacing the cover" on page 38.
5. Thread the cable through the U-bolt and around an object that is not a part of

Installing memory modules

Adding memory to your computer is an easy way to make programs run faster.
You can increase the amount of memory in your computer by installing memory
modules. Your NetVista computer uses industry-standard, RAMBUS in-line
memory modules (RIMMs).
Notes:
1. Any connector that does not have a RIMM installed must have a continuity
2. Install only ECC RIMMs to enable ECC. If you use ECC and non-ECC memory
3. RIMM connectors do not support dual inline memory modules (DIMMs).
4. Use only PC600 or PC800 RIMMs.
5. Your NetVista Types 6838 and 6848 computers support 128 MB, 256 MB, and
U-bolt
Bolt holes
Nuts
appropriately sized or adjustable wrench.
or permanently secured to the building structure or foundation, and from
which it cannot be removed; then fasten the cable ends together with a lock.
RIMM (C-RIMM), a module that looks like a RIMM but has no memory on it.
A C-RIMM is used to continue the connection on a RIMM connector that does
not have memory installed.
together, it will function as non-ECC memory.
Note: If you use PC600 and PC800 RIMMs together, all memory will function
at the speed of the slowest RIMM.
512 MB RIMMs. Your computer supports a minimum of 128 MB and a
Chapter 5. Installing options Type 6838, 6848
33