Cd-Rom Drive Jumper Settings - IBM NetVista Hardware Maintenance Manual

3. Install the drive into the bay. Align the screw holes and insert the two screws.
4. If the drive you installed is a removable-media drive, remove the bay panel
from the front bezel and place the bezel frame that comes with your computer
over the drive bay.
5. Connect the power and signal cables to the drive.

CD-ROM drive jumper settings

CD-ROM and PC/CD-ROM drives use jumpers or tabs to set the drives as primary
(master) or secondary (slave). Refer to the drive connector labels or the figures
below for the drive settings.
AUDIO
39
R G G L
40
See Jumper
Settings Below
CD-ROM Primary (Master)
48X
IDE INTERFACE DC INPUT
1
5V G G 12V
2
: :
Chapter 5. Installing options Type 6838, 6848
Secondary (Slave)
: :
29