HP Brio 80xx Upgrade Manual page 62

2 Remove the old battery by sliding it from under the retaining clip (note the position of the cross marked on the battery).
3 Place the new battery in the battery holder, with the cross in the same position as on the old battery (the cross should
be facing up from the board), and ensure that it is properly seated. Ensure that the clip holds the battery firmly in place.
After installing a replacement battery, install any other accessories before replacing the cover, then reconnect the power
cords and any telecommunications cables. Run the Setup program to reconfigure the computer.
Removing the battery will clear the CMOS, returning the configuration to their default settings. Refer to the
Note
Advanced Setup Guide for information on reconfiguring your system.
2 Installing Accessories in Your Computer
Changing the Battery
62