HP Brio 80xx Upgrade Manual page 51

6 Install any other accessories before replacing the cover and reconnecting the power cords and any telecommunications
cables.
7 Turn on the display, let it warm up, and then turn on the computer. Press
is displayed at the bottom of the screen. This displays a series of screens that show the computer's configuration details.
Check that the new drive is recognized (it is shown on the Main screen in the Primary / Secondary, Master /
Slave fields).
Before you can use the new hard disk drive, you will probably need to set up partitions and then format the drive. To
do this, restart your computer in MS-DOS mode, run fdisk to set up the partitions, restart the computer, and then
format the new drive from within Windows 95.
Troubleshooting
If the new drive is not recognized, you may need to run the Setup program: restart the computer and press
Press <F2> to enter SETUP is displayed at the bottom of the screen.
If the new drive is still not recognized, check that you have correctly followed the installation procedure described
above.
If there are any errors reported during the computer's startup routine, press
necessary action.
If you cannot start your computer properly, remove the drive and try starting your computer again. If the computer
now starts OK, there may be a problem with the new drive.
If you experience any other problems as a result of the upgrade, refer to the online support center.
2 Installing Accessories in Your Computer
Installing Storage Devices
when Press <F2> to enter SETUP
to view the error(s) and take any
when
51