HP Brio 80xx Upgrade Manual page 50

2 Install the new hard disk drive in the computer:
•
For a 3.5-inch hard disk drive – mount the new hard disk drive in the bay under the power supply unit at the rear of
the computer. Have the connectors of the new hard disk drive pointing towards the front of the computer.
•
For a 5.25-inch hard disk drive – mount the new hard disk in the bottom 5.25-inch bay at the front of the computer.
Have the connectors of the new hard disk drive pointing towards the back of the computer.
3 Secure the drive to the computer using the four screws provided with the drive. Two screws must be inserted in each
side of the drive. Using screws other than those provided may cause damage to the device.
4 Connect the power and data cables to the rear of the drive. The power connector is shaped to fit one way only. Refer
to the drive's manual(s) for the orientation of the data connector. Use the second to last connector on the hard disk
drive data cable. Refer to
5 If the system board drawer was pulled-out, slide the system board drawer back into the computer chassis.
"System Board Connectors" on page 47
Data Cable
2 Installing Accessories in Your Computer
for an illustration of the cables and connectors.
Storage Device
Power Cable
Installing Storage Devices
50