HP Brio 80xx Upgrade Manual page 54

10 Connect the power and data cables to the rear of the device. The power connector is shaped to fit one way only. Refer
to the drive's manual(s) for the orientation of the data connector. Refer to
more information about which connectors to use.
Data Cable
11 If the system board drawer was pulled out, slide it back into the computer chassis.
12 Install any other accessories before replacing the cover and reconnecting the power cords and any telecommunications
cables.
13 Turn on the display, let it warm up, and then turn on the computer. Press
is displayed at the bottom of the screen. This displays a series of screens that show the computer's configuration details.
Check that the new drive is recognized (it is shown on the Main screen in the Diskette or Primary / Secondary,
Master / Slave fields).
Depending on the type of drive you have installed, you may need to install some driver software.
2 Installing Accessories in Your Computer
"System Board Connectors" on page 47
Storage Device
Power Cable
when Press <F2> to enter SETUP
Installing Storage Devices
for
54