Determining The Ip Address Using The Local Console - HP BladeSystem bc2000 - Blade PC User Manual

Determining the IP Address Using the Local Console

To determine the Integrated Administrator IP address using the local console perform the following
steps:
1. Access the Integrated Administrator console:
a. Connect a local client device (such as a laptop computer) with VT100 terminal emulation
software to the Integrated Administrator (serial) console connector using a null modem serial
cable.
b. Open a terminal emulation session with the following settings: 9600 bps, 8 data bits, no parity,
and 1 stop bit.
c. Log into the Integrated Administrator using the password on the settings tag attached to the
interconnect tray.
2. Establish the Integrated Administrator IP address.
For a detailed explanation of the command line conventions used in this document, see
Line Conventions on page
If a DHCP server is attached to the network, determine the Integrated Administrator IP address.
Type the following command at the command line interface:
SHOW NETWORK
If a DHCP server is not attached to the network, type the following commands sequentially to assign
a static IP address to the Integrated Administrator:
SET IPCONFIG STATIC <IP address><subnet mask>
SET GATEWAY <IP address>
SET DNS <primary address> {<secondary address>}
You can now access the Integrated Administrator using a Web browser, Secure Shell, Telnet, or
SNMP.
CAUTION:
12 Chapter 3 Getting Started
121.
All settings are immediate and can only be manually restored.
Command
ENWW