Kyocera KM-4800w Operation Manual page 23

For "Roll Deck 1 Detail" and "Roll Deck 2 Detail" press the R1 Key or R2 Key to enter Roll
Deck Settings.
On this screen the following settings can be changed.
For "Roll Deck 1 Media", press the L1 Key repeatedly for the media type.
For "Roll Deck 2 Media", press the L2 Key repeatedly for the media type.
For "Roll Deck 1 Offset", press the R1 Key repeatedly for the media offset.
For "Roll Deck 2 Offset", press the R2 Key repeatedly for the media offset.
The available Media Type settings are "Plain", "Vellum" and "Film".
"Media Offset" will adjust horizontal shift of the print area.
"Media Offset" can obtain a precise centering of the print area even if it is impossible for a roll
media to be loaded to the center for some reason.
For example: The print area will be moved 8mm to the right with setting "Roll Deck 2 Offset" to
"8 to the right".
To specify "Roll Deck 1 Offset", press the R1 Key to choose Left or Right and enter a value
with the Numeric Keys.
To specify "Roll Deck 2 Offset", press the R2 Key to choose Left or Right and enter a value
with the Numeric Keys.
"Media Offset" covers 0 to 20mm in increments of 1 millimeter.
Press the Enter Key to apply the setting.
Note:
All the setting in Paper Width/Media/Offset settings will not be reset with the Reset Key or
power off.
22