Display - Gateway MT6704h Reference Manual

You see an "Access Denied" or "Write protect" error
message
•
•
•
•
You see a "Disk is full" error message
•
•
•
You see a "Non-system disk," "NTLDR is missing," or "Disk
error" error message
•
•
The diskette drive status indicator is lit continuously
•

Display

The screen is too dark
•
The screen resolution is not correct
•
104
CHAPTER 9: Troubleshooting
Move the write-protection tab in the upper-right corner
of the diskette down (unprotected).
The diskette may be full. Delete unnecessary files on the
diskette and try again.
Not all diskettes are IBM-compatible. Make sure that the
diskette you are using is IBM-compatible.
Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
Delete unnecessary files on the diskette.
Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
Run Error checking on the diskette. If errors are detected
and corrected, try using the diskette again. For
instructions on running Error checking, see "Checking
the hard drive for errors" in your online User Guide.
Eject the diskette from the diskette drive, then press
E .
NTER
Make sure that the diskette you are using is
IBM-compatible.
Remove the diskette from the drive. If the indicator stays
on, try restarting your notebook.
Adjust the brightness using the system keys or Windows
Mobility Center. For more information about adjusting
the brightness, see
page 35.
Change the screen resolution from the Display Settings
dialog box. For instructions on changing the screen
resolution, see "Changing the color depth and screen
resolution" in your online User Guide.
"Adjusting the brightness" on