Connecting The Power Cord - Brother DCP-130C - Color Inkjet - All-in-One Quick Setup Manual

Note
When you use Legal size paper, press and hold
the universal guide release button as you slide out
the front of the paper tray.
5
Gently adjust the paper side guides with both
hands and the paper length guide to fit the
paper.
Make sure that the paper side guides and
paper length guide touch the edges of the
paper.
Note
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
6
Close the output paper tray cover.
Setting Up the Machine
7
Slowly push the paper tray completely into the
machine.
8
While holding the paper tray in place, pull out
the paper support (
unfold the paper support flap ( ).
Note
Do not use the paper support flap for Legal paper.
3

Connecting the power cord

1
Connect the power cord.
Improper Setup
DO NOT connect the USB cable. Connecting
the USB cable is done during the software
installation process.
Note
The control panel warning LED will stay on until
you have installed the ink cartridges.
) until it clicks, and then
5