Yamaha Clavinova CVP-609 Reference Manual page 95

Display
Pop-up Display Time
Transition Effect
Voice Area
Touch Sound
Panel
Calibration
Parameter Lock
This function is used to "lock" specific parameters (effect, split point, etc.) to make them selectable only via the panel
control — in other words, instead of being changed via Registration Memory, One Touch Setting, Music Finder, or Song
and sequence data.
To lock the desired parameter, touch the corresponding box to enter the checkmark. To unlock the parameter, touch the
box again.
USB Memory
This lets you execute the Format operation or check the memory capacity (approximate value) of the USB flash memory
connected to this instrument. For details on instructions, refer to the Owner's Manual.
System
For information about this display, refer to the Owner's Manual.
Factory Reset/Backup
Factory Reset — Restoring the Factory Programmed Settings
On page 1/2, checkmark the boxes of the desired parameters then touch [Factory Reset] to initialize the settings of the
parameters which are checkmarked.
System Restores the System Setup parameters to the original factory settings. Refer to "Parameter Chart"
in the Data List for details about which parameters belong to the System Setup.
MIDI Restores the MIDI settings including the MIDI templates saved in the internal User memory to
the original factory status.
CVP-609/605 Reference Manual
Determines the time that elapses before the pop-up windows close. Pop-up windows
appear when you press buttons TEMPO [-]/[+], TRANSPOSE [-]/[+], SONG
CONTROL [ ](REW)/[
"Hold" is selected here, the pop-up window is shown until you touch [X].
Turns on or off the Transition Effect which is applied when the display is changed.
Determines which keyboard parts are shown in the Voice area of the Home display.
When "Show Active Parts Only" is selected, only the active keyboard parts are shown.
When "Show All Parts" is selected, all the keyboard parts are shown.
Determines whether or not touching the display will trigger the click sound.
Lets you calibrate the display when it does not respond properly to your touching
(Normally, you do not need this operation, since it is calibrated by factory default).
Touch here to call up the Calibration display, then touch the center of "+" in order.
](FF), or REGISTRATION BANK [-]/[+]. When
Making Global Settings (Utility)
95