Changing The Rhythm Volume/Reverb - Yamaha Electone STAGEA ELB-01 Owner's Manual

4
NOTE
Depending on the volume
value (set in the display),
two adjacent Volume button
lamps may be lit at the same
time, indicating an
intermediate position.
Reference Page
Reverb Depth (page 48)
62 ELB-01 Owner's Manual

Changing the rhythm volume/reverb

You can adjust the rhythm volume or amount of reverb applied to the rhythms and the
percussion sounds used in the rhythms in the Rhythm Condition display. You can also
have a Fill In play automatically by setting the Auto Fill function to ON.
To call up the Rhythm Condition display, select the desired rhythm and press the same
rhythm button again.
[Page 1] Rhythm Condition Display
<PERCUSSION>"AUTO.F⁄
VOL.¿12
2
The buttons at the right and left side of the display and DATA CONTROL dial can
control the rhythm volume and reverb.
1
Auto Fill
When Auto Fill is set to On (") in the display, the Fill In pattern is automatically
played whenever you switch the Main sections.
For details on how to set to On, see page 17.
2
Volume
Fine Adjustment of rhythm volume.
Press the [C] button to make the "¿" indicator flash, then use the DATA CONTROL
dial to change the setting.
Range: 0 – 24
3
Reverb
Determines the amount of reverb applied to the rhythm.
Press the [D] button to make the "÷" indicator flash, then use the DATA CONTROL
dial to change the setting.
When the Reverb Depth (for entire instrument) is set to the minimum, the setting here
will have no effect.
Range: 0 – 24
1
REV.÷ 8
3