Advertisement
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the Inner cover component
Before initial use of the machine, assemble the inner cover as described below:
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming
the inner cover shaft to the installation hole of the
corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the corresponding
outer tub cover shaft groove, then push the another inner cover shaft
into the corresponding outer tub cover shaft groove. Please install to
designated position to guarantee there are no dropping or abnormal
sound in opening and closing of the inner cover, and the operation shall
be smooth. Do not dismount the inner cover component after washing.
Install the bottom plate
After you open the package, please lean
the washing machine gently down on soft
items ( like the towel cloth, blanket, etc. ).
Install the bottom plate to the bottom of
the machine with the eight screws by
a cross screwdriver, then lift the machine
up gently. See to the figure:
Two claws at the bottom cover shall
be inserted in two bar-shaped holes
in the stand. Make sure the claws
are firmly in place.
Outer tub cover
Outer tub cover shaft groove
Inner cover shaft
Inner cover
Damping cushion
Section I enlarging
Push
I
Back
Front
Bottom plate
Soft items
Section I enlarging
3 Push "SOAK/FUCTION" "WASH/SPEED" "RINSE"
"SPIN/SPEED" button to select suitable procedure program
Attention
Even there's no water in the tub, a certain period is required before spin starting.
Separate the laundries that are not colorfast from other laundries in washing.
The soak procedure can work in cooperation with automatic programs like standard, carpeting
chemical fiber. There is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing,
and can not make setting in other cases.
If the water pressure is too low, in order to wash the closes cleanly, the machine will change
from " SAVING WATER "to "storing water "automatically.
4 Push the " WATER LEVEL "button, select
suitable water level
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth.
After defection, it can set the water level automatically. To select other water level, first push the "START/PAUSE"
button, then push the "WATER LEVEL" button to set the water level.
5 Push the "RESERVE" button to select suitable
reserve wash program
After switching on the power, the reserve program is set to off mode automatically. If you need to
set the washing procedure to be finished at reserved time, please push the " RESERVE " button to
set the reserve wash program. Refer to reserve button in Page 10 for selection.
Confirm the operation of reserve program
When the "RESERVE" function is activated, the indicator light of the program you
have set will be off. The "reserve (hour)" and "time remain" indicator lights will
be on. During reserve procedure, push the "RESERVE" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
6 Push the "START/PAUSE" button
6 Finish washing
After finishing wash
WATER LEVEL
RESERVE
START/PAUSE
it'll alarm automatically
Advertisement
