Removing And Replacing The Cover; Desktop Models - HP Vectra VEC 7 Supplementary Manual

Hide thumbs Also See for Vectra VEC 7:

Table of Contents

WARNING:

Removing the Cover

Replacing the Cover

Removing and Replacing the Cover

For your safety, never remove the PC's cover without first removing the

power cord from the power outlet, and any connection to a

telecommunications network. Always replace the cover before switching on

the PC again.

1 Switch off the display and the PC.

2 Disconnect all power cords and any telecommunications cables.

3 Unscrew the three thumb screws at the back of the PC. If it is the first time

you are removing the cover, you will probably need to use a screwdriver

to loosen the screws.

4 While standing at the back of the PC, slide the cover towards you by about

20 mm (about 1 inch) and then lift it off the PC chassis.

Step 4

1 Make sure that all internal cables are properly connected and safely

routed.

2 Standing at the back of the PC, lower the cover onto the PC chassis

(aligning the rails on the inside edges of the cover with the sides of the PC

chassis), and firmly slide the cover forwards into position.

Step 3

Table of Contents

Vectra ve c/xxx 7 Vectra ve c/xxx series