Removing And Replacing The Cover And Front Bezel - HP Linux workstation x1100 Getting Started Manual

setting up and using your workstation

removing and replacing the cover and front bezel

Figure 1-6
AGP Card Slot
Three PCI Card
Slots
WARNING
24
HP Workstation x1100 System Board
removing and replacing the cover and front bezel
For your safety, never remove the workstation cover without
first disconnecting the power cord from the power outlet and
removing any connection to a telecommunications network. If a
Power Protection Device is fitted to your workstation, you must
shut down your computer using its on/off switch, then remove its
power cord before removing the workstation's cover. Remove the
Power Protection Device cables before any servicing operation.
Always replace the cover before switching the workstation on
again.
Memory module sockets supporting
two DDR modules
Processor connector
(heatsink and
processor not shown)
Primary IDE
Connector
Secondary IDE
Connector
Floppy Disk Drive
Connector
Chapter 1