Using The Control Panel - EdgeStar AP420HS Owner's Manual

Operation – Using the Control Panel
Control Panel Parts
1. Fan speed button
2. Timer button
3. Display window
4. Senor for remote control
5. Heat mode indicator
6. Mode (function) button
7. Automatic mode indicator
8. Cooling mode indicator
9. Fan mode indicator
10. Temperature up button
Turning the Unit On or Off
Press the 'POWER' button and the unit will start in auto mode. If the ambient temperature is:
o
- Higher than 73 F, the unit will operate in cool mode.
o
- Higher than 68 F but below or equal to 73
o
- Below 68 F, the unit will operate in heating mode.
An indicator will display next to the corresponding mode.
*NOTE: The display window shows the ambient room temperature from 32
To turn the unit off, press the Power button again.
Selecting Between Automatic, Cooling, Heating, or Fan Modes
Press the MODE button to select the desired mode: automatic, cool, heat or fan.
The indicator of your selected mode comes on.
FIG.10
11. Temperature down button
12. Power indicator
13. Water full indicator
14. Power button
15. Sleep mode button
16. Compressor indicator
17. Sleep mode indicator
18. Timer indicator
19. Low fan speed indicator
20. High fan speed indicator
o
F, the unit will operate in fan mode.
o o
F to 122 F
9