Using The Remote Control - EdgeStar AP420HS Owner's Manual

3. To turn off sleep mode, re-press the 'SLEEP' button, the setting temperature and
fan speed will return to the pre-selected one.
4. The sleep function will automatically shut down the unit after 12 hours of continuous
use.
Note: The sleep function is not available while the unit is in fan, or auto mode. Sleep
mode is only available in cooling or heating mode.
Operation – Using the Remote Control
1
2
3
4
5
NOTICE !
1. To prolong the compressor's life, please wait at least 3 minutes before turning the
unit back on after shutting it off.
2. The cooling system will shut off if the ambient temperature is lower than the set
one. The fan, however, keeps working on the set level. If the ambient temperature
rises above the selected level, the cooling system will return to operation.
3. The heating system will switch off if the ambient temperature is higher than the set
one. The fan, however, keeps working on the set level. If the ambient temperature
drops below the selected level, the heating system will return to operation.
4. This machine is equipped with an ANTI-FROST function. While using the heating
function in freezing weather, the heating function may stop blowing warm air, in
order to melt frost. Once frost is melted the unit will return to blowing warm air out.
All the control panel functions can also
be set with the remote control.
1. LED Indicator – Lights up when
6
2. Power Button – Used to power the
3. Sleep Button – Used to set the
7
4. Timer Button – Used to set the
8
5. Down Button – Used to decrease
6. Mode Button – Used to change
Note: The
remote uses
two AAA
7. Fan Speed Button – Used to set
batteries.
8. Up Button – Used to increase the
FIG.11
you press any of the buttons.
unit on or off
sleep function.
timer function.
the temperature.
between auto, cooling, heating, or
fan modes.
the fan speed.
temperature.
11