Thank You Thank you for purchasing an EdgeStar portable air conditioner. It should provide you with years of reliable cooling. Among other features, this versatile unit exhausts all the condensate that it extracts from your air. Additionally, this portable air conditioner features auto restart. If power to the unit is interrupted, the unit “remembers”...
Cooling conditions: Dry bulb/Wet bulb: 95/75°F according to European standard EN14511-2004 Operating limits for cooling: Maximum ambient conditions: Dry bulb/Wet bulb: 100/80° F Minimum ambient conditions: Dry bulb/Wet bulb: 64/57°F AP310SS 115 Volts / 60 Hertz See Label on Unit Pints Hours...
3 hours prior to turning it on. 8. Always place the unit on a level surface. 9. In order to cool, the hot air from the exhaust port in the rear of the portable air conditioner must be exhausted outside the room.
Page 6
15. Do not tilt the portable air conditioner. 16. Do not cover or obstruct the intake or outlet grills. 17. Do not use the portable air conditioner in a wet room- such as a bathroom or laundry room- to avoid the possibility of shock.
Parts and Accessories 1) Parts Ai r I nl et Ai r Fi l t er C ast er O per at i on Panel Ai r O ut l et C ont r ol Si gnal R ecept or Ai r I nl et f or condenser si de H andl e...
W at er D r ai n H ose Installation When you use this portable air conditioner as an air conditioner or a dehumidifier, the hot air should be exhausted out of the room. When the unit is operating in fan-only mode, no exhaust is required.
1) Exhaust Hose Installation The exhaust hose must be installed onto the unit before any further installation can occur. a) Pull out about 6” of one end of the exhaust hose. b) Screw the exhaust connector onto the exhaust hose in a clockwise motion. c) Snap the exhaust connector into place in the back of the unit.
If necessary, the window kit can be cut to size. e) Place the window kit in your window, with the exhaust hole as near as possible to the portable air conditioner. f) Close the window on the window kit. For long-term installation or to make the window kit more stable, you may want to screw the window kit into your window frame.
Feed as much exhaust hose as is needed through the hole. Notes: Be sure to cover the hole when it is not being used by the portable air conditioner. Be sure to have a qualified person make the hole to avoid the possibility of injury or of unintended damage to your room.
Page 12
DOWN Temperature / Time Buttons These buttons are used to adjust the thermostat setting up or down, or to adjust the time setting when using the timer. NOTE: The temperature can be displayed in Celsius or Fahrenheit. To change from one scale to another, press and hold the On/Off button for 20 seconds.
timer display will begin to blink. While it is blinking, press the timer button again. The time will disappear from the Timer Display and an “F” will be displayed. The timer has now been cancelled. 2) Remote Control The six buttons on the remote control are same as the six buttons on the control panel of the main unit.
Fan-only mode does not require that the exhaust hose be attached. 4) Water Drainage All air conditioners dehumidify the air as they cool. This portable air conditioner is designed to evaporate and exhaust this condensed water (sometimes called condensate). When using the Cooling or Dehumidifying modes under extremely humid conditions, the internal water tray may fill completely.
When the flow of water stops, you can turn off the portable air conditioner. Remove the drain hose and reinstall the drain cap. The unit will now be almost completely drained. If you were draining the unit to allow it to continue cooling or dehumidifying, simply turn the unit back on to the settings you want.
1) Filter This portable air conditioner has a washable pre-filter that filters contaminants out of the air. This pre-filter should be cleaned about once every two weeks or as needed. If it becomes clogged with dust, the efficiency of the unit will be lowered.
5) Take out the filter. Clean and dry it (see the instructions above), and reinstall it. 6) Cover the portable air conditioner to protect it from dust. It is generally a good idea to store the unit in its original box and packaging.
Troubleshooting Problem The portable air conditioner does not turn on The unit turns on, but the compressor does not turn on- the fan runs, but there is no cooling The air coming out of the unit is not very cold, or the airflow...
Page 19
You may need additional cooling or another air conditioner You may need additional cooling or another air conditioner, or you may need to add insulation Make sure the unit is level Call for service Move the unit to a location with a...
Circuit Diagram R ecei ver PC B O per at i on Panel PC B M ai n C ont r ol PC B PO W ER SU PPLY R oom W at er Level Tem p D et ect or Sensor AC - N 0 AC - N 1 AC - N...
Limited Warranty This EdgeStar product is warranted to be free from defective workmanship and materials for the first year following the date of original purchase. Replacement parts will be supplied free of charge for the first year following the date of original purchase. Labor will be performed free of charge for the first 90 days following the date of original purchase.
Page 22
Contact EdgeStar for troubleshooting assistance and warranty service authorization at 1-866-319-5473. Please have your order receipt available to confirm the date of purchase. Once an EdgeStar authorized representative has confirmed that your product is eligible for warranty service, the product must be returned to an EdgeStar authorized repair facility.