Table of Contents
Advertisement
General features
System Q
You can recall the best sound setting preset for different types of
the music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [Q] button.
Each time the button is pressed the sound setting switches.
Sound setting
Flat
Rock
Top 40
Pops
Jazz
Easy
Scan of Flat — Easy
User memory
• User memory: The values set on the <Audio control> (page 8).
• Each setting value is changed with the <Speaker setting> (page
8).
First, select the speaker type with the Speaker setting.
Audio Control
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
Display
"Flat"
"Rock"
"Top 40"
"Pops"
"Jazz"
"Easy"
"Scan"
"User"
— 8 —
switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item
Display
Bass Center Frequency
"Bass F"
Bass level
"Bass"
Bass Q Factor
"Bass Q"
Bass Extend
"Bass EXT"
Middle Center Frequency "MID F"
Middle level
"Middle"
Middle Q Factor
"Middle Q"
Treble Center Frequency
"TRE F"
Treble level
"Treble"
Balance
"Balance"
Fader
"Fader"
Volume offset
"V Offset"
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
1.00/1.25/1.50
2.00
• When the Bass Extend is set to ON, low frequency response is
extended by 20%.
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
5
Exit Audio Control mode
Press the [AUD] button.
Speaker Setting
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
Range
60/70/80/100 or 150 Hz
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
0.5/1.0/1.5/2.0 kHz
–8 — +8
1.0/2.0
10.0/12.5/15.0/17.5 kHz
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
–8 — ±0
Bass Center Frequency
60/70/80/100
60/70/80/150
Advertisement
Table of Contents
