Transceiver / Pager-Remote - CrimeStopper CS-2014.DPII.FM.TW2 Operation Instructions Manual

PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and
receive information from the vehicle. The Control Module
transmits High Frequency FM/FM signals from the vehicle
to your over long distances. Your range will vary
depending on location,
noise/interference. This system is not guaranteed to page
you if you are behind concrete walls, underground, in a
large structure, or in an area with high levels of electronic
interference. Handle the pager/remote with care if the
LCD display and/or the electronics may be damaged if
subjected to abuse. The AAA Cell 1.5V alkaline battery
can easily be replaced by sliding open the battery access
door on the back of the remote.
depending on usage. The LCD screen will display a low
battery icon when the battery is low.
"Range Questions" on page 17.
Button Button Functions
Lock Doors & Arm System
Unlock Doors
System
Trunk Release (Aux # 1)
Aux #2
Start or Stop engine
2-car operation (Side Button)
Press and Hold two seconds
to change from Car 1 to Car
2

TRANSCEIVER / PAGER-REMOTE

terrain, and
Battery life will vary
For more
Button Options
Press and Hold
seconds
Activate "Panic" feature
& Disarm Press twice for second door
unlock
Press and Release for Aux
#1
Press and Hold button #2 &
#3 for 3 sec.
Press and Hold
seconds
Press and release to light up the LCD screen.
Press and release twice to recall the last message from the LCD screen.
Press 5 times to change the Time and Disable or Enable Beep on the remote. See page 19 for details.
#1 ARM
local RF
LOCK
#5 RECALL
CAR I or II
#3 TRUNK
see
Buttons
for 3
for 3
3
FIXED
ANTENNA
AM
Button Functions Button Options
Aux#3 Press Button #1 and #4 at
the same time
Aux #4 Press Button #3 and #4 at
the same time
Car Jack Press Button #1 and #3 at
(See page 14) the same time
Silent Arm/Disarm Press Button #2 and #4 at
the same time
#2 DISARM
UNLOCK
LCD
SCREEN
#4 ENGINE
START/STOP