Operating Instructions - Alarm - CrimeStopper CS-2014.DPII.FM.TW2 Operation Instructions Manual

OPERATING INSTRUCTIONS - ALARM

Active Arming / Locking:
Press button #1 (Lock symbol) on the transceiver. The System will arm emit one siren chirp,
one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter
disable circuit will turn on. LCD Pager will beep once while displaying a Locking symbol. After
a short delay to allow the vehicle and electronics to settle, the system will be completely
armed.
Disarming: / Unlocking
Press button #2 (Unlock symbol) on the transceiver. System will disarm and confirm with two
siren chirps, two light flashes, and the LED will turn off. Power locks will unlock and Interior
ARM-LOCK
Dome light will turn on (if installed with these optional features). LCD Pager will beep twice
while displaying an Unlock symbol.
Alarm Triggers:
If there is an intrusion into the vehicle, a hard impact to the body or the ignition is turned on,
the alarm will sound and flash the lights for 1 minute. After 1 minute, the trigger cycle will
automatically stop and alarm will remain armed to continue protecting the vehicle. If a door is
left open after an intrusion then the unit will cycle a maximum of 2 minutes and continue to
protect the other un-tampered or unopened zones.
LCD Remote Paging / Zone Violations:
When the system is triggered, the alarm sends a paging signal to the remote. If you are within
DISARM-UNLOCK
range, you will receive a violation paging signal that consists of a vibration followed by 5
beeps to notify
audible you the vehicle has been tampered with.
DOOR TRIGGER SHOCK SENSOR HOOD/TRUNK
IGNITION TRIGGER
TRIGGER
5