5-4.3. Sensor Connection And Relay In &Out - Clover CDR-0850 Instruction Manual

Instruction Manual
Stand-alone DVR
-
5-4.3. Sensor Connection and RELAY IN &OUT
▫ SENSOR Connection (SENSOR IN)
Connect the sensor to ALM (SENSOR) IN. The Sensor should be a contactor type and support
NO (Normal Open).
Refer to
[Fig. 5-6 SENSOR IN/OUT PIN]
▫ RELAY OUT Connection
When necessary, use RELAY OUT. The Output of RELAY OUT is a relay contactor type and
supports NO (Normal Open) & NC (Normal Close). The Output capacity is 220V 1A. A higher
capacity can cause system failure.
Refer to [Fig. 5-7] for
for connection.
[Fig 5-6. SENSOR IN/OUT PIN]
the connection to RELAY OUT.
[Fig 5-7]
26