Installation; 5-4.1. Camera Connection; I Nstallation 5-4.1. Camera Connection; 5-4.2. Monitor Connection - Clover CDR-0850 Instruction Manual

Instruction Manual
Stand-alone DVR

5-4. Installation

5-4.1. Camera Connection

▫ Connection of Normal Cameras
Connect the cameras to the Video Input (BNC connector) on the back of the unit as shown
above [Fig. 5-3 System Connection].
▫ Connection of Loop Output
The Camera or video output is available from the Video Output (Loop Output) on the back of
the unit. (When BNC jack is connected to the Video Output, the termination resistance (75Ω)
is automatically switched to impedance status so the external device must have termination
resistance.)

5-4.2. Monitor Connection

▫ Connection of Main Monitor
Connect the composite monitor to "Main" on the upper part of BNC connector
▫ Connection of Auxiliary Monitor
Connect the auxiliary monitor to "Aux" on the lower part of BNC connector. The output of
auxiliary monitor port is the same as the main monitor.
▫ Connection of S-VHS Monitor
Connect the S-VHS monitor cable to "S-VHS" DIN jack on the rear of the unit. Output for S-
VHS monitor is the same as that of main or auxiliary and works independently
Pin configuration of S-VHS connector.
[Fig 5-4. S-VHS Connector PIN]
24